Programming

• Programm starting procedures
• Tools running procedures
1. Sequence No
2. Goto Home
3. Select Tool
4. RPM and Spindle Direction Selection
5. Coolant On
6. Move Rapid to safe point near component
7. Component Operation Done
8. Release to safe point near component
9. Coolant off
10. Spindle off
11. Move to home point
12. Optional stop program stop if need
• Program end sequence

Programm starting procedures

Program no if fanuc 4 digit code followed by Letter O,Any special code need to input as per MTB Instructions.then start the program

Tools running procedures

Sequence No

To identify tool special lines require to call as sub program macro call run from mid of of the program we need specific line address so give a line no followed by N letter do not give same line no another line.

Goto Home

When start we dont know where is tool located in mc so safely move to its tool changing position its always safe point.move to home but refer that tailstock,or steadyrest used then check move that how do home that axis

Select Tool

RPM and Spindle Direction Selection

Coolant On or air mist on

Move Rapid to safe point near component

Component Operation Done

Release to safe point near component

Coolant off

Check Coolant off

Spindle off

Spindle off and if need orientation the spindle do that need

Move to home point

same as starting home the mc need safely move to its tool changing position for next tool change.move to home but refer that tailstock,or steadyrest used then check move that how do home that axis

Optional stop program stop if need

Program end sequence

Cancel all active code.coolant off tailstock return.Parts count code then finish with M30